Oregon ContractorCheck

Which Oregon licences you need to see for roofing, electrical, plumbing and remodeling jobs

Which Oregon licences to ask to see for remodels, roofing and other trades, electrical, plumbing, HVAC, decks and landscaping, with questions to ask each contractor.

Oregon regulates home work through more than one agency, and a single project can involve several licences. Knowing which licence belongs to which part of the job helps you ask the right questions before you sign. This guide is general information, not legal advice, and rules change, so confirm current requirements with the agencies linked below.

Start with the CCB, then look beyond it

Most contractors who work on homes in Oregon must be licensed by the Construction Contractors Board (CCB). You can look any contractor up on the CCB's licence search, which shows the endorsement, status, bond and insurance. This site's listings come from the same public file, and list only contractors with an unexpired residential endorsement plus a bond and insurance on file. That is a positive check on those items only. It does not tell you about workmanship or complaints, and it does not cover other agencies' licences. A practical way to use it: search for the contractor, note the endorsement and expiry date, and write the CCB number on your contract next to the company's name. For the basics of reading a CCB record, see how to verify an Oregon CCB contractor licence.

Remodels and additions

A residential general contractor can plan and manage a remodel or addition and bring in specialists. For a project of this kind:

A short example of how a split can look on a home project, with illustrative job types only: a kitchen remodel might involve the general contractor (CCB), a licensed electrician for new circuits, a licensed plumber for moving the sink and a tile specialty contractor for the floor. Each step should have its own permit where required and an inspection before the walls are closed. Ask for a written schedule that shows when inspections will happen, and do not make the next payment until the work has passed.

Roofing, siding, flooring and other trades

Trade contractors typically hold a residential specialty endorsement. The CCB record does not tell you which trade the company does, so ask what work it does, how long it has done it and whether it uses its own crew. Ask for local references and photographs of finished jobs, and get the warranty in writing. For roofing, ask about the underlayment, flashing and ventilation, not just the shingles, and for siding or windows, ask how the company handles water-resistive barriers and flashing, since water damage is where problems tend to appear later.

Electrical and plumbing

Electrical and plumbing work is regulated by the state's Building Codes Division and needs its own licences and permits. A contractor who does this work should be able to show the licence numbers for the business and for the people doing the work, plus a permit for the job. A CCB licence alone is not the whole answer. If a remodeler plans to do wiring or pipework with their own crew, ask who holds the electrical or plumbing licence, and look it up with the Building Codes Division before work starts.

Never agree to "pull a permit as the owner" simply because a contractor suggests it, unless you understand what you are taking on. Owner permits can shift responsibility for the work to you. Ask the building department of your city or county what it requires, and what inspections you will see.

HVAC and heat pumps

Heating and cooling installation can involve construction, mechanical and electrical licences and permits. Ask which licence covers each part, whether the system was sized with a load calculation instead of a rule of thumb, and what the warranty says about parts and labor. Oregon and its utilities have run incentive programs for heat pumps and efficiency upgrades, some of which require a participating contractor. Check current program rules before you sign, and do not rely on a salesperson's summary.

Decks, fences, windows and doors

Decks and retaining walls above certain sizes need permits and structural review. Ask for the plan, the permit and the inspection record, and look at the footings, the ledger attachment and the flashing, which are common failure points. A deck ledger pulled off the house by poor fastening is a well-known cause of collapses, so ask how the ledger will be attached and flashed. For replacement windows and doors, ask about flashing, sealing and disposal of the old units, and whether the warranty is transferable if you sell. Fences are often exempt from permits below a height set by the local jurisdiction, so check with your city or county.

Landscaping, painting and older homes

Landscaping work is licensed by the Landscape Contractors Board rather than the CCB. Some jobs, such as retaining walls and decks, involve construction, so ask which licence covers which part. If your home was built before 1978, the EPA's Renovation, Repair and Painting rule requires firms hired to disturb painted surfaces to be certified and to follow lead-safe work practices. Ask any painter or remodeler for their EPA certification before work starts.

Questions for any contractor

  1. What is your CCB number, and which endorsement do you hold?
  2. Who is the responsible managing individual?
  3. What licences apply to the electrical and plumbing parts of the job, and who holds them?
  4. Who pulls the permits, and when will inspections happen?
  5. May I see a certificate of insurance?
  6. What is your payment schedule, and do you provide lien releases?
  7. Which parts of the work will subcontractors do?
  8. If this is a pre-1978 home, are you EPA lead-safe certified?

Getting three bids. For any of these jobs, collect at least three written bids on the same scope, check each company's licence and insurance, and talk to recent customers. If one bid is far lower than the others, ask what it leaves out. For what happens when a job goes badly, see bonds, insurance and CCB complaints.

Always check current rules at the Construction Contractors Board before you hire. If your project is on the Washington side of the Columbia River, see our sister site Washington Contractor Check.

Updated 2026-10-02.

General information only, current as of the date above. The information on Oregon Contractor Check is not a recommendation or a guarantee of anyone's work. A license record shows registration status on the date shown, not workmanship, insurance coverage at the time of your job, or suitability for your project. Confirm license, insurance and permits directly before you hire. Rules and programs change; check the official sources linked in this guide.

Find contractors